Bitbucket allows us to create a private remote repository based on Mercurial. If you don’t care that the source code can be stolen, you can use his service as your distributed revision control tool. However, if your code contains sensitive data and you would like to host a Mercurial on your server, you can follow the steps below to install and configure Mercurial on Ubuntu.
1. Switch user
The commands must be run under superuser access. So remember to write sudo before each command mentioned below.
2.1. Install Mercurial and Apache
apt-get update apt-get install apache2 apt-get install apache2-utils apt-get install mercurial
To test if Apache was successfully installed, use command below
To test if Mercurial was successfully installed, use command below
2.2 Install Keyring
To save a user from entering the password each time he pushes changeset, we can use extension Keyring to store password.
apt-get install python-pip pip install keyring pip install mercurial_keyring
3.1 Configure Mercurial
3.1.1 Create main folder
Create folder for hosting all repositories and change owner to www-data user.
cd /var/ mkdir hg mkdir hg/repos chown -R www-data:www-data hg/repos
Create hgweb.cgi to list all repositories over web interface and allow the hgweb.cgi to be able to execute.
cd /var/hg cp /usr/share/doc/mercurial/examples/hgweb.cgi . chmod +x hgweb.cgi nano hgweb.cgi
Edit config of hgweb.cgi as following
config = "/var/hg/hgweb.config"
Create hgweb.config to configure where hgweb.cgi should look for the repositories.
cd /var/hg nano hgweb.config
Enter following lines
[paths] / = /var/hg/repos/*
3.1.2 Extended configurations
Allow pushing changeset via HTTP (not only HTTPS)
Add following lines
[web] allow_push = * push_ssl = false
3.2 Configure Apache
Configure Apache to map hgweb.cgi to a relative path of server.
cd /etc/apache2/site-available nano 000-default.conf
Add following part right before node
ScriptAlias /hg "/var/hg/hgweb.cgi" <Location /hg> AuthType Basic AuthName "Mercurial repositories" AuthUserFile /var/hg/hgusers Require valid-user </Location>
Enable CGI module in Apache
service apache2 restart
3.3 Create users
Create users who can access the repositories
cd /var/hg htpasswd -mc hgusers user1
Enter the password for the user. For next users, don’t use argument c
cd /var/hg htpasswd -m hgusers user2
Test if the created user can access the repositories. Use your browser to browse to your_server/hg, you will be asked for username and password.
cd /var/hg/repos mkdir hintdesk cd hintdesk hg init
4.2 Give permission
cd /var/hg/repos chown -R www-data:www-data hintdesk
If you get “Permission denied” at TortoiseHg, then execute these commands
cd /var/hg/repos/hintdesk chmod -R 777 .hg
5. Configure client
On the client site where you check out source code with TortoisHg, browse to the folder where you have your code. Go to .hg, edit hgrc file. Add following lines
[auth] default.schemes = http default.prefix = your_server/hg default.username = user_name_defined_in_hgusers [extensions] mercurial_keyring =